What is the default username and password to login to BLiNQ CPE's?
Summary :
Article Outlines the default username and password to access BLiNQ CPE's.
Question :
What is the default username and password to access BLiNQ CPE's?
Customer Environment :
Customer using BLiNQ CPE's and requiring access to the BLiNQ CPE's.
Procedure :
There are two modes available for accessing the CPE's.
1. User mode - Allows to view and perform limited configuration settings to CPE.
2. Super user - Allows to view, modify and perform all configurations on the CPE.
Use the following username and password to access the different modes :
1. Usermode :
Username : admin
Password : admin
2. Super user
Username : administrator
Password : _BLiNQ_
Related Articles
FWC-110HG-35 CPE User Manual
Before proceeding, please read and observe all instructions and warnings in the guide. Do a thorough check of all the items in the boxes for any missing or damaged items. If any of the items are missing or damaged, DO NOT INSTALL OR OPERATE THE UNIT. ...
FWC-110HG-35 CPE Datasheet
FWC-110HG-35 CPE IS A CATEGORY 6 LTE CPE SUPPORTING BLINQ MASSIVE MIMO FW300I/600 SOLUTION. Here are some key features: Supports TDD-LTE Mode Band 42, 43 & 48 * Supports 3GPP Release 10 compliant (Support Cat 6; 40MHz Aggregation)/Future Rel 11 ...
FWC-122HG-35 CPE User Manual
Before proceeding, please read and observe all instructions and warnings in the guide. Do a thorough check of all the items in the boxes for any missing or damaged items. If any of the items are missing or damaged, DO NOT INSTALL OR OPERATE THE UNIT. ...
CAT 6 High Gain - FWC-110-35 HG CPE Antenna patterns
Summary : This article consists of antenna pattern files for BLiNQ FWC-110-35 HG CPE The antenna pattern file is a simple pafx , msi or xml file that describes the main characteristics of the antennas - radiation patterns, gain, frequency range, ...
FW-300i User Manual and Configuration Guide
This manual contains informational and overview chapters and then continues as a guide to the recommended order that you configure and then monitor your FW-300i system. There are two methods to configure the FW-300i: FW-300i Web-based User Interface ...