This manual contains informational and overview chapters and then continues as a guide to the recommended order that you configure and then monitor your FW-300i system.
There are two methods to configure the FW-300i:
- FW-300i Web-based User Interface (WebUI) (recommended) or
- Command Line Interface (CLI)
Each chapter contains step-by-step instructions for the applicable method. Choose either the FW-300i WebUI or the CLI method and follow the procedures under the desired chapter.

Note: This guide covers instructions for following FW300i models
- FW3-B48-00-NA
- FW3-B48-00-HP-NA
- FW3-B42-43-EU
- FW3-B42-43-HP-EU
The WebUI menu structure is the basis for the order of the chapters and the processes contained within those chapters:
- Initial system setup: See Chapter 4, “Getting Started with the FW-300i”
- Configuration: See Chapter 5, “Configuration” for configuring the FW-300i system using:
- WebUI; See Section 5.2, “Configuration with the WebUI” or
- Command Line Interface (CLI); See Section 5.3, “Configuration with the CLI”
- Operation and Maintenance: See Chapter 6 , “Operation and Maintenance”
- Management: See Chapter 5.2.5.4.4, “Heartbeat Interval, Tx expire buffer time, TCP Keep-Alive
- Software upgrade
- Performance containing eNB and Customer Premise Equipment (CPE) statistics plus trace log files and measurements
- Events including alarms and past events (History)
- Troubleshooting
- Administration: See Chapter 5.2.5, “Management” (for WebUI) and Chapter 5.3.6, “Management via the CLI”
- User operations (Local security)
- Simple Network Management Protocol (SNMP)
- Syslog server

Please proceed to download the document attached.