FWC-110-35 CPE Datasheet

FWC-110-35 CPE Datasheet

FWC-110-35 CPE IS A CATEGORY 6 LTE CPE SUPPORTING BLINQ MASSIVE MIMO FW300I/600 SOLUTION.

Here are some key features:
  1. Supports TDD-LTE Mode Band 42, 43 & 48 *
  2. Supports 3GPP Release 10 compliant (Support Cat 6; 40MHz Aggregation)/Future Rel 11
  3. Supports up to UE LTE Category 6 PHY Rate
  4. Supports 1.8V and 3V SIM and USIM card for LTE Mode
  5. Supports 1TX/2RX with TX switched diversity
  6. Supports Dynamic Host Configuration Protocol
  7. Built-in web server for web-based configuration
  8. Password-protected access and configuration
  9. Supports IEEE 802.3, IEEE 802.3u, IEEE 802.3 ab (10/100/1000 Mbps )
  10. Supports Power over Ethernet of Outdoor WAN port {802.3 at}
  11. Supports VPN pass-through
  12. IP67 Environmental Proof
  13. * B48 will be supported upon FCC certification-ready in future SW release

    • Related Articles

    • BLiNQ FWC-122HG CAT12 CPE CBSD - SAS Interoperability Test Results

      Summary : This Article consists about information on BLiNQ CAT 12 CPE that has passed interoperability test with SAS vendor as Federated Wireless on IoT code version 1.7  BLiNQ CAT 12 CPE's are CBRS certified and compliant under FCC part 96 rules and ...

    • FWC-122HG-35 CPE User Manual

      Before proceeding, please read and observe all instructions and warnings in the guide. Do a thorough check of all the items in the boxes for any missing or damaged items. If any of the items are missing or damaged, DO NOT INSTALL OR OPERATE THE UNIT. ...

    • FWC-110HG-35 CPE User Manual

      Before proceeding, please read and observe all instructions and warnings in the guide. Do a thorough check of all the items in the boxes for any missing or damaged items. If any of the items are missing or damaged, DO NOT INSTALL OR OPERATE THE UNIT. ...

    • FWC-110-35 CPE User Manual

      Before proceeding, please read and observe all instructions and warnings in the guide. Do a thorough check of all the items in the boxes for any missing or damaged items. If any of the items are missing or damaged, DO NOT INSTALL OR OPERATE THE UNIT. ...

    • What is the default username and password to login to BLiNQ CPE's?

      Summary : Article Outlines the default username and password to access BLiNQ CPE's. Question : What is the default username and password to access BLiNQ CPE's? Customer Environment : Customer using BLiNQ CPE's and requiring access to the BLiNQ CPE's. ...